F3A Alliance from ZN Line

Hello, i need help and i am wondering if you can help me. I just bought new Alliance kit but without manual. Does any one have one spare for leaning or sending trough email. I would be very grateful.

Thanks in forward and have a nice week start
Jasenko

 

Did you contact ZN line? I assume they have the manual available....

 

I might still have the papers lying around here somewhere, I'll take a look..

 

Yes I send them mail but still no response. Hope that someone have one around.
Thanks Henri, hope you will find them.

 

Maybe you'll already find what you need in my build thread:
afbouwverslag-znline-alliance

There's not much manual to it.

 

I have seen your build thread already and it is very helpful but I must confess that my Dutch is not on that level yet. I can understand a “beetje” Dutch but still I need all information about measurements and positions for Center of gravity, incidence details and other useful info.

 

They're not in the manual.

Incidence: wing about 0.4 degrees, stab 0.

CG: 28% of MAC.

To find MAC:
http://www.airfieldmodels.com/infor..._aircraft/formulas/mean_aerodynamic_chord.htm

 

I'm sorry, I checked, as it turned out I ditched the manual the last time I cleaned out the attic.

So no help there, all I can say I started with wing 0.5 and stab 0 and changed that to wing 0.4 stab 0, which was fine.

 

Thank you very much Henri. I will try to use your build treat as much is possible.