Tail/main rotor mixing on a Eco V2 with Heading Lock

JD

JD

Hello again everyone :)

I just read that HH gyros wont work properly unless you have mixing off. There were no instructions that came with the HH module for the picoboard plus so im a little confused as to how the proper setup should be. Currently my mix is set at about 1 o'clock.

Should I

a) Turn this completely counter clockwise when the HH module is installed?
b) leave it as it is?
c) give up and go have a beer?

cheers,
jd
 
Just don't use any revo mix in you're transmitter. then it should be ok.
I think you should turn the mixing off on the board, but I'm not sure. just try it (and have a beer ;) ) :proost:
 
The module is an (software) add on for the piccoboard plus, so everything will be ok without tampering.
 
Ahh... It seems that I confused revo mix with something else. Whats the difference between revo mix and the mixer pot on the picoboard plus?

jd
 
If you use revo mix the board doesn't know if you are the one that’s steering or the transmitter.
If you throttle up de revo mix automatically add right rudder. This is ok with a normal gyro, but a HH gyro tries to keep the tail on one spot until you steer the ruder. The HH gyro will see the revo mix as an user input to steer the tail.
 
You must log in or register to reply here.
Back
Top